a) Complete the following methods description using the correct tense for the verb in brackets. (This student is using passive voice rather than any human agents at the request of the instructor.) Student Lab Report Identical tensile test procedures were performed on all test specimens. Each of the metal specimens __1 [have] an indentation near the center to ensure that the fracture point would occur in this region. Tension tests 2 [conduct] as follows. Two pieces of reflective tape 3 [place] approximately 1 inch apart in the center of the specimen where the indentation 4 [locate]. The width and the thickness of the specimen at this location _5_ [measure] using a Vernier caliper. Then the specimen _6 [secure] in the MTS Load Frame. A laser extensometer _7_ [place] into position to measure the deformation of the specimen. The laser extensometer ____8_ [use] to measure the original distance between the pieces of reflective tape. The MTS __9 [set] to elongate the specimen one tenth of an inch every minute.

Question

02-07-2021
Engineering

contestada

a) Complete the following methods description using the correct tense for the verb in brackets. (This student is using passive voice rather than any human agents at the request of the instructor.) Student Lab Report Identical tensile test procedures were performed on all test specimens. Each of the metal specimens __1 [have] an indentation near the center to ensure that the fracture point would occur in this region. Tension tests 2 [conduct] as follows. Two pieces of reflective tape 3 [place] approximately 1 inch apart in the center of the specimen where the indentation 4 [locate]. The width and the thickness of the specimen at this location _5_ [measure] using a Vernier caliper. Then the specimen _6 [secure] in the MTS Load Frame. A laser extensometer _7_ [place] into position to measure the deformation of the specimen. The laser extensometer ____8_ [use] to measure the original distance between the pieces of reflective tape. The MTS __9 [set] to elongate the specimen one tenth of an inch every minute.

Respuesta :

Otras preguntas

Which of the following is a TRUE statement about the partitioning of Africa by European imperialist nations during the 1800s? A. New nations were based on old t

The effect of pH on the action of a certain enzyme is shown on the accompanying graph. Rate of Enzyme Action 0 1 2 3 4 5 6 7 8 9 10 11 12 13 pH What is the doma

how many fifths must be added to 6/10 to make a whole

Based on the table, what can you infer about Truman's goal for the nuclear attack on Japan? A) Truman wanted to disrupt Japan's ability to wage war. B) Truman

The two triangles above are similar. What is the value of x ? A) 5 B) 7.5 C) 8 D) 13 1/5

it is movable marker that measures short distance and correct thickness such as distance between buttons pleats and hems

I need help :ppppppppp

what does equal (+3) * (+9)=

This member of the Continental Congress helped gain French support for American independence. A. Thomas Jefferson B. Benjamin Franklin

jayilych4real jayilych4real · Answer 1 · 2021-07-07T06:58:59+02:00

Answer:

Each of the metal specimens HAS an indentation near the center to ensure that the fracture point would occur in this region. Tension tests WERE CONDUCTED as follows. Two pieces of reflective tape WERE PLACED approximately 1 inch apart in the center of the specimen where the indentation 4 WAS LOCATED. The width and the thickness of the specimen at this location WAS MEASURED using a Vernier caliper. Then the specimen WAS SECURED in the MTS Load Frame. A laser extensometer WAS PLACED into position to measure the deformation of the specimen. The laser extensometer WAS USED to measure the original distance between the pieces of reflective tape. The MTS WAS SET to elongate the specimen one tenth of an inch every minute.